HFE which had created by HxC-software (and thereafter copied to the SD-card)Ģ. What whatever I tried, I could not get the HxC to "boot" the. No other floppy at same time connected as floppy controller of my mainboard supports only one drive. I have put the Jumper 2 (ID1A) of the HxC to ON, as I am using a twisted floppy cable with HxC at end. I disabled Disk Drive Selector as I am - at this time - only using one "floppy" (from HxC). HFE once made (dumped) from the real floppy. HFE is booted ? Does the HxC then appear as a Floppy in the Bios? Of course, I have created and copied a HXCSDFE.CFG to the FAT32-formatted 32GB-SD-card (not sure however whether I had configured the HxC-setting properly - I selected IBM-PC 1.44MB as HFE file interface mode). But what to do and how to configure the HxC2001 so that the. dump a 1.44MB Boot-Floppy (MSDOS 7.1) which is booting (Floppy selected as boot-device in Bios) when I used it in a real floppy (3.5). With regard to usage, I have following questions :ġ. Connected it to Floppy Controller of Mainboard (Asrock).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |